User Manual

MK-101 Pro24 JCS TROUBLESHOOTING

Cooling Flow

(A)

Verify the cooling ow

Adjusting Clamp is open. If ow

exists, go to Step A.

(B)

Remove the Cooling Transfer

Tube from the Blade Guard

inlet. Go to Step C.

(C)

Place Pump into a bucket of

water and check ow. If ow

exists, go to Step D.

(D)

Remove the Cooling Transfer

Tube and check for ow. If ow

exists, refer to water manual.

(E)

Remove the Blade Guard

Intake Fitting. Go to Step J.

(F)

Remove the Cooling Channel

cover screws.

(G)

Rod the Cooling Channels

and then recheck ow.

“Rodding” cooling channels is performed by inserting

a small wire rod through the cooling inlet on top of the

Blade Guard and directing the rod out through each of

the cooling ow tubes located on the underside o the

Blade Guard. The cooling channels should be “rodded”

until all ports are free of foreign debris.

NOTE: