Owner's manual

MK-101 Pro24 JCS OPERATION

To cut 45° Miters, the 45° Bullnose Miter Guide (MK Diamond Part No. 153201-

MK) should be used.

CAUTION

DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which

it was designed.

45° Miter Cutting

NOTE:

(A)

Position the 45º Bullnose Miter

Guide and tighten the

retaining thumbscrew.

(B)

Position the tile on the 45º

Bullnose Miter Guide and the

Ruler/Stop. Turn the motor ON.

(C)

Verify proper cooling ow on

both sides of the blade (See

Maintenance Section to

increase/decrease ow).

(D)

Perform the cut. Turn the motor

OFF when work is complete.