Chainsaw User Manual

MK CX-3 Revision 09/04, Effective Date September 17, 2004 Page 11
UNPACKING, TRANSPORT and ASSEMBLY
2. Cutting Pointer Arm Installation:
3. Diamond Blade Installation:
NOTE: When installing the diamond blade retaining-bolt, ensure the threads of the bolt are aligned with the
threads of the drive shaft so as not to “cross-thread" the bolt.
(B)
Locate the Blade Retaining Screw,
the Outer and the Inner Flange
(A)
Open the Blade Guard Cover
Direction
to Open
Cove
r
Inner and Outer
Flanges
Retaining
Screw
(C)
Install the Pointer Wheel, the
Pointer and the Pointer Retaining
Cli
p
(B)
Tighten the Nylock Nut and 3/4-
inch screw
(A)
Install the Pointer Arm using the
Stop Clip, a 3/4-inch screw, flat
washer and a Nylock Nut
(F)
Rotate the Pointer down
(E)
Rotate the Pointer Arm into the
upright position
(D)
Tighten the Retaining Clip
Thumbscrew
Stop Clip, Screw,
Flat Washer and
Nu
t
Pointer Ar
m
Tighten
Retaining
Clip
Pointer
Wheel
Pointe
r
Retaining
Clip
Thumbscrew
Rotate
Pointe
r
Rotate