Owners manual

37 Flod cloth away from other end to expose slate slatron for your fourth./
glue application See Figure 15 Apply cement to this end in the same.( )
mannerl Allow cement to become tacky wait at least one minute.,.
38 Make a final stretch along the length of and over the edge of the table. ,
stretch hard enough to work out all wrinkles See Figure 17 If cloth.( ).
is not not smooth lift and re apply Rubbing fingers lightly,-.:NOTE
across cloth should not make cloth move.
39 Locate center of pocket opening Using..See Detail A and B()
sharp scissors make a straight cut Next cut to pocket edge to form,.,
pie shapes begin to relax to allow for placement You may need.
to make additional cuts.
40 Spray adhesive on the underneath side of the slate slatron around./
pocket face to adhere the cloth Make sure not to get overspray of.
glue on table Allow cement to become tacky wait at least one.,
minute Stretch the pie shapes down and under the pocket opening..
Press the cloth against the cement ont the underside of the slate/
slatron Be sure entire pie shape is fully attached to underneath side.
of table.
DO NOT SMOKE WHILE WORKING WITH
CONTACT CEMENT READ LABEL ON CEMENT
CONTAINER CAREFULLY
!
!
APPLYING THE CLOTH
29 Make sure slate slatron is dry and free of dust./ .
NOTE Before spraying adhesive cut a portion of th shipping:,
carton to use as a shield to prevent cement overspray.
30 Place cloth over slate slatron with equal overhang on all sides./ .
NOTE Cloth may seem small but it will stretch fa great deal:.
31 Fold cloth away from end to expose slate slatron for your first glue./
application Apply contact cement to top surface in a band 4 inches.
wide on this end See Figure 12 Coat edge also Spray cement.( ) .
smoothly and evenly Allow cement to become tacky wait at least.,
32 Fold cloth back over the table With firm even pressure press cloth...
33 Fold cloth away from side to expose slate slatron for your second glue./
application See Figure 13 Apply cement to the side in the same.( ).
manner as your first glue application Allow cement to become tacky.,
wait at least one minute.
34 Fold cloth back over the table With firm even pressure press cloth..,
onto the area that has been coated with cement Smooth cloth down.
and over edges.
35 Fold cloth away from other side to expose slate slatron for your third./
glue application See Figure 14 Apply cement to this side in the.( ).
same manner allow cement to become tacky wait at least one.,
minute.
36 Stretch the cloth across the width and over the edge of th table. .
STRETCH HARD ENOUGH TO TAKE OUT WRINKLES BUT,
NOT SO HARD THAT THE CLOTH SLIPS.
onto the area that has been coated with cement Smooth cloth down.
Figure 12
Figure 13
Figure 14
Figure 15
Figure 16
Detail B
Detail A
Page
9