Owner Manual

P16 Ball Return Support Board

P3A & P3B End Slat

SAME

DIMENSION

201 2 Escalad e Sports

Fo r Custome r Servic e Cal l 1-866-556-2757

ST E P 2 :

Attach each P2 Main Metal Beam to P1 Leg assembly as shown Figure 2 using H1 Bolts, H3 Washers,

H2 Lock Washers and H4 Hex Nuts. Use the T4 Wrench to assemble the hardware. Do not tighten

hardware at this time. Place P3 A and P3B End Slats and P4 Middle Slats across P2 Main Beams and

attach using H5 Bolts, H3 washers, H2 Lock Washers and H4 Hex Nuts as shown in Figure 2.

Attach P5 End Boards to P3A End Slat using pre-drilled pilot holes with H6 Screws as shown in Figure 2.

Attach P16 Ball Return Support Board to P3B End Slat using pre-drilled pilot holes with H6 Screws as

shown in Figure 2.

STEP 3:

Square up P4 Slats by measuring diagonally as show in Figure 3. Diagonal measurements should be

the same within 1/8". If the frame is not square, adjustment can be made by moving table beams P2 in

opposite directions. Once the frame is square, tighten all hardware.

Figure 3

PARTS REQUIRED:

8 pcs - H1 Bolt

16 pcs - H2 Lock Washer

32 pcs - H3 Washer

16 pcs - H4 Hex Nut

8 pcs - H5 Bolt

2 pcs - P2 Main Metal Beam

2 pcs -

2 pcs - P4 Middle Slat

2 pcs - P5 End Board

1 pc -

1 set - T4 Wrench

P3A

IMPORTANT NOTE:

Make sure holes are located on the

top of both P2 Main Metal Beams.

Note: P5 End Boards must be

8 pcs - H6 Screw

flush or slightly lower than top

of P3A End Slats.

P3B

Figure 2

P16