Owner Manual

STEP 6:

P10

NOTE:

All parts are

upside down

Onaclean level surface, lay each P9 Side Top Rail and P10 End Top Rail face down as shown in Figure 15.

Next, lay each P11 Corner Cap face down and attach using H8 Bolts with H15 Flat Washers as shown in

Figure 15 and Detail A. Do not tighten H8 Bolts at this time.

Next, Measure from the outer edge of cushion rubber, on each side of P10 End Top Rail to other end of P10

End Top Rail . These two measurements must be the same in order for this rail assembly to be a perfect

rectangle and should measure approx 87 5/8". This measurement may vary slightly from 87 5/8", but both

measurements must be the same. Hold each P10 End Top Rail down with your hand and tighten H8 Bolts - in

the end top rail only. Check to see that both measurements are still the same.

Next, Measure from the outer edge of cushion rubber, on each end of P9 Side Top Rail to other end of P9 Side

Top Rail. These two measurements must be the same in order for this rail assembly to be a perfect rectangle

and should measure approx 43 1/2". This measurement may vary slightly from 43 1/2", but both measurements

must be the same. Hold each P9 Side Top Rail down with your hand and tighten H8 Bolts - in side top rail only.

Check to see that both measurements are still the same.

Lastly, Check all (4) measurements to insure this assembly is a perfect rectangle and double check that all

corner cap bolts are tight.

2012 Escalade Sports

For Customer Service Call 1-866-556-2757

PARTS REQUIRED:

8 pcs - H8 Bolt 2 pcs - P10 End Top Rail

8 pcs - H15 Flat Washer 4 pcs - P11 Corner Cap

2 pcs - P9 Side Top Rail

Figure 15

P10

H15

P11

P10

Approx 87 5/8”

Approx 43 1/2”

Approx 87 5/8”

Approx 43 1/2”