Owner Manual

THE FOLLOWING STEP REQUIRES
THE HELP OF ANOTHER ADULT!
STEP 5:
You can tell the top side of the playfield sections by the beveled edge of the pocket openings
and the countersunk mounting holes. The beveled edges and the countersunk holes must
face
up. (See Detail A)
much as you can. The playfield sections are 51 inches wide. The P4 Middle Slats are 51 inches
long,
The play bed sections should be flush with the P4 Middle Slats on both sides of
table.
This step requires two adults! WARNING:
REMEMBER: Be sure countersunk holes in the playfield face up!
B) Secure center section P7 to long slats P4 with screws H7 into countersunk holes.
important that the edges of the three pieces of playfield are flush and square.
DO NOT OVER TIGHTEN SCREWS!
Place end Play Bed section P6 onto slats.Be sure they are square,in line and butted up
tight
against center section P7.Secure end section P6 to beams using screws H7 into
countersunk holes.
DO NOT OVER TIGHTEN SCREWS. NOTE:If necessary,shim underneath
TOP OF PLAY BED MUST BE PRECISELY LEVEL! EDGES MUST BE EVEN WITH ONE
ANOTHER!
Be sure that the side
of the table top
sections with the
countersink around
each hole face up
Detail A
10
©
2012 Escalade Sports
For Customer Service Call 1-866-556-2757
H7
H7
H7
H7
H7
H7
P6
P7
P6
P4
P4
A) Place center section P7 on the two long slats P4.If edges do not align exactly,center playfield as
Note:It is
Play Bed where they join together to obtain a smooth,even surface.Shims are provided in the slate
bed kit.
Figure 9
H7
H7
PARTS REQUIRED:
16 pcs - H7 Screw
2 pcs - P6 End Play Bed
1 pcs - P7 Middle Play Bed
All Rights Reserved.
Playbed sections must be flush with
P4 Middle Slats on both side of table.
Note: See next page for
Playfield Shimming Instructions.