Owner Manual

Table Of Contents

SA M E

DIMENSI O N

P 4

201 2 Escalad e Sports

Fo r Custome r Servic e Cal l 1-866-556-2757

ST E P 2 :

Attach each P2 Main Metal Beam to P1 Leg assembly as shown Figure 2 using H1 Bolts, H3 Washers,

H2 Spring Washers and H4 Hex Nuts. Use the T4 Wrench to assemble the hardware. Do not tighten

hardware at this time. Place P3 End Slats and P4 Middle Slats across P2 Main Beams and attach

using an H5 Bolts, H3 washers, H2 Spring Washers and H4 Hex Nuts. Attach the P5 Metal Beam End

Boards using H6 Screws.

ST E P 3 :

Square up P4 Slats by measuring diagonally as show in Figure 3 . Diagonal measurements should be

the same within 1/8". If the frame is not square, adjustment can be made by moving table beams P2 in

opposite directions. Once the frame is square, tighten all hardware.

Figure 2

Figure 3

P ARTS REQUIRED:

8 pcs - H1 Bolt

16 pcs - H2 Spring W asher

32 pcs - H3 W asher

16 pcs - H4 Hex Nut

8 pcs - H5 Bolt

8 pcs - H6 Screw

2 pcs - P2 Main Metal Beam

2 pcs - P3 End Slat

2 pcs - P4 Middle Slat

4 pcs - P5 Main Beam End Board

1 set - T4 W rench

IMPORTANT NOTE:

Make sure holes are located on the

top of both P2 Main Metal Beams.

Note: P5 Main Beam End Boards must be flush

or slightly lower than top of P3 End Slats.