Owner Manual

13
©
2012 Escalade Sports
For Customer Service Call 1-866-556-2757
All Rights Reserved.
STEP 7:
With the rail assembly face down, place a P13 End Apron flush against the bottom of the P10 End
Top Rail and align using threaded inserts on the underside of each rail. Attach the end apron as
shown using H9 Bolts with H10 washers (see inset). Do not tighten yet. Attach opposite P13 End
Apron. Do not tighten yet.
Next, slide each P14 Corner Post over the edge of each P13 End Apron. Do not attach the Corner
Post yet. Next, slide one P12 Side Apron into the Corner Post, hold flush against the rail and attach
all aprons to top rails using H9 Bolts with H10 Washers. Do not tighten yet. Be sure each P14 Corner
Post is flush with each apron, then attach using H11 Screws. Lastly, tighten all H9 Apron Bolts.
Figure 16
H9
H10
H11
P13
P12
P14
P13
P12
PARTS REQUIRED:
12 pcs - H9 Bolt
12 pcs - H10 Washer
24 pcs - H11 Screw
2 pcs - P12 Side Apron
2 pcs - P13 End Apron
4 pcs - P14 Corner Post
Note:
Be sure each corner
post is flush with each
apron.