Owner`s manual

C
M
J
CM
MJ
CJ
CMJ
N
vibe-watermark-bright.pdf 03/04/2009 16:07:52vibe-watermark-bright.pdf 03/04/2009 16:07:52
4 Configuring CROSS
4.1 Audio Configuration
1 Go to [File > Preferences > Audio].
C
M
J
CM
MJ
CJ
CMJ
N
config_audio.pdf 07/12/2009 17:41:30config_audio.pdf 07/12/2009 17:41:30
Audio Configuration Pane
2 Select MixVibes ASIO U46MK2 on PC or U46DJ on Mac from the pull down menu.
3 Choose your desired sample rate and buffer size . The default settings are 44.1kHz sample rate and
512 samples of buffer.
4 Select the outputs of the U46MK2 corresponding to the mixer channels.
5 Select the inputs of the U46MK2 corresponding to the decks that will playback the control vinyl/CDs.
6 If you use control vinyls , set the input level to Phono . If you use control CDs , set the input level to Line .
Make sure to follow the connection instructions in section 2. CROSS applies an RIAA correction in "bypass
mode" (Line Input on the CROSS mixer) so that you can play regular vinyls.
7 Select your routing mode. If you are using an external mixer, select the routing mode External Mixer.
Here is a description of the different routing modes:
Simple Stereo The sum of the master and cue signals are routed to outputs 1/2 on your U46MK2.
Dual Stereo The master signal is routed to outputs 1/2 and the cue signal is routed to outputs 3/4 on your
U46MK2.
Split Mono The master and cue signals are folded down to mono. The mono master is routed to output 1 and
the mono cue is routed to output 2 on your U46MK2.
External Mixer Deck A direct out is routed to outputs 1/2 on your U46MK2, Deck B direct out is routed to
outputs 3/4. and the cue out is routed to outputs 5/6.
10 / 21