User Manual

C
M
Y
CM
MY
CY
CMY
K
vibe-watermark-bright.pdf 25/10/2010 17:41:48
10 Frequently Asked Questions
How do I upgrade my controller’s firmware?
1 Make sure your controller is connected via USB to the computer.
2 Power the device OFF.
3 Press and hold the SHIFT and BROWSE buttons of the U-MIX CONTROL 2.
4 Power the device ON, keep holding the SHIFT and BROWSE buttons.
5 Both "SOURCE(AB)" buttons should light up (SHIFT and BROWSE buttons shouldn’t be pressed anymore).
6 A new drive named "midiUpgDisk" should be found in your system.
7 Drag and drop the firmware file ("U-MIX_2_*V*.bin") into the "midiUpgDisk" drive.
8 The Kill-LEDs will start to flash while upgrading: BASS(AB): Update Data (30%), MID(AB): Update Data
(60%), TREB(AB): Update Data (90%), LOAD(AB): Update Success (if LOAD(AB) Turn Off means Updating
Error).
9 After the firmware is updated, the LEDs will turn off.
Can I use U-MIX CONTROL 2 with DJ software other than CROSS DJ
LE?
Yes, your U-MIX CONTROL 2 is a standard MIDI controller that sends MIDI commands. U-MIX CONTROL 2 can be
used with any software that accepts MIDI commands.
How can I record the mixes that I create with the U-CONTROL MIX 2?
You can record your mix by choosing whether you want to save the channel A, B or Master and then by clicking on
the REC button present in the upper part of the integrated mixer of CROSS DJ LE. You can customize the recording
settings in [File > Preferences > Recording].
22 / 24