User Manual

C
M
Y
CM
MY
CY
CMY
K
vibe-watermark-bright.pdf 25/10/2010 17:41:48
1 Connections
1.2 Turntables/CD Players and Internal Mixer Setup
1 If you are using vinyl, plug the ground of your turntable to the ground lug on the U-MIX CONTROL PRO.
2 Connect the outputs of your decks (vinyl or CD) to the RCA inputs of your U-MIX CONTROL PRO plugging
the left deck into the inputs 1/2 and right deck into the inputs 3/4. Match the left channel (usually white)
with the white RCA sockets on the U-MIX CONTROL PRO, and right (usually red) with the red sockets.
3 If you are using turntables with phono outputs, set the U-MIX CONTROL PRO’s input selectors to ’Phono’.
If you are using turntables with line outputs or CD players, set the input selectors on the U-MIX CONTROL
PRO to ’Line’.
4 Connect outputs 1/2 of your U-MIX CONTROL PRO to your sound system (amplifier, powered speakers, or
home stereo).
5 Connect your headphones to one of the ’headphones’ outputs of your U-MIX CONTROL PRO.
6 If necessary, connect your microphone to the ’microphone’ input of your U-MIX CONTROL PRO.
7 Connect the supplied USB cable between the USB output of your U-MIX CONTROL PRO and a free USB slot
of your computer.
8 To turn on your U-MIX CONTROL PRO, set the rear panel selector to ’USB’.
9 After installing the software, set the CROSS DJ Audio preferences as described in the Audio Configuration
part of this manual: 3.1 on page 12.
REAR
FRONT
LN PH
LN PH
DC IN
OUTPUT 3/4
POWER
INPUT 3/4 INPUT 1/2
9V
0.5A
TOUCH SENSOR
MIN MAX MIN MAX
OUTPUT 1/2
LR LR LR LR
USBOFF
C.F. CURVE
LEVEL
R L
HEADPHONES
L R
MICROPHONE
USB
SPEAKERS TURNTABLECD PLAYER
PHONO
LINE
LN PH
PHONO
LINE
LN PH
SOFTWARE
MIXVIBES
Turntables/CD Players and internal mixer setup
6 / 30