Installation Sheet

HL263201, HL263202, HL263203, HOLLY SCONCE
www.hudsonvalleylighting.com/mitzi| #mymitzi
ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
• WARNING-DISCONNECT POWER BEFORE RELAMPING OR
WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL
CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
• INSTALLATION AND MAINTENANCE OF THIS FIXTURE
SHOULD BE COMPLETED BY A LICENSED ELECTRICAN
• FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN
SERIOUS INJURY OR DEATH
• READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
• IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT AND
NOTE TO WHICH WIRE IN THE OUTLET BOX THE ORIGINAL
FIXTURE WAS ATTACHED.
• BEFORE DISCARDING THE CARTON DOUBLE CHECK THE
PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
• THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN
OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY
MOUNTED TO THE STRUCTURE OF THE BUILDING.
INSTALLATION
STEP 1. Remove the fixture and parts bag(s) from the carton.
STEP 2. Attach the mounting plate to the wall and mark the
targets on the wall from the set holes. Remove the
mounting plate.
STEP 3. Drill the holes and thread anchors into the holes.
STEP 4. Attach the mounting plate to the wall then thread the
wall mounting screws through the set holes into the
anchors,
STEP 5. Place Back plate over the mounting plate and secure with
set screws.
STEP 6. Install the lamp(s). The fixture is rated for 25 watt type T
lamp.
DO NOT EXCEED RECOMMENDED WATTAGE!
STEP 7. Plug cord into a qualified socket of properly rated
voltage.
STEP 8. On/Off switch installed on cord.
DIMMING
The fixture can be controlled by a wall dimming device. Only use
triac/electronic dimmer. Make sure carton is marked for use with LED
compact fluorescent-incandescent light source only. These can be
provided by your local electrical distributor, home center, or
hardware store.
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products.