Installation Sheet

H516806 H516808 H516815 BAILEY CHANDELIER
www.hudsonvalleylighting.com/mitzi| #mymitzi
ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
• WARNING-DISCONNECT POWER BEFORE RELAMPING OR
WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL
CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
• INSTALLATION AND MAINTENANCE OF THIS FIXTURE
SHOUILD BE COMPLETED BY A LICENSED ELECTRICAN
• FAILURE TO INSTALL FIXTURE CORRECTLY COULD
RESULT IN SERIOUS INJURY OR DEATH
• READ ALL INSTRUCTIONS BEFORE STARTING
INSTALLATION.
• IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT
AND NOTE TO WHICH WIRE IN THE OUTLET BOX THE
ORIGINAL FIXTURE WAS ATTACHED.
• BEFORE DISCARDING THE CARTON DOUBLE CHECK THE
PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN
FOUND.
• THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN
OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY
MOUNTED TO THE STRUCTURE OF THE BUILDING.
INSTALLATION
STEP 1. Pull the wires out from the outlet box, and install mounting
plate onto the outlet box using the (2) mounting screws.
STEP 2. Thread the wire through stem and twist tightly onto body.
STEP 3. Choose the length of the chain you need. (to remove
excess chain section, use pliers to bend link open)
STEP 4. Thread the fixture wire and the ground wire through the
chain, collar, canopy and top loop assembly. connect the
chain to the loop and top loop.
STEP 5. Trim excess wire to min 6” beyond stem, strip to 5/8” and
twist.
STEP 6. Fasten bare ground wire to ground wire from the wall outlet
box (usually green or copper color) or connect ground wire
to green screw on the mounting plate.
STEP 7. Connect the neutral (white) fixture wire coming from the
fixture base to neutral (usually white) outlet wire. Fasten
both wires together with a plastic wire nut and tightly wrap
the wire nut with electrical tape.
STEP 8. Repeat the previous step with the hot (black wires). Make
sure there are no exposed wires or strands that could
cause a dangerous short circuit.
FAILURE TO CONNECT THE APPROPRIATE WIRES
CORRECTLY COULD RESULT IN SEROIUS INJURY OR
DEATH!
STEP 9. Carefully place connections back into the outlet box.
STEP 10. Attach the canopy to the mounting plate by inserting the
top loop, then secure it with collar.
STEP 11. Attach the finial onto the bottom of the fixture.
STEP 12. Install the lamps. The H516806 and H516808 is rated for
60 watt type G lamp, the H516815 is rated for 40 watt type
G lamp.
DO NOT EXCEED RECOMMENDED WATTAGE!
STEP 13. Restore power to the circuit at breaker or fuse box.
DIMMING
The fixture can be controlled by a wall dimming device. Only use triac
/electronic dimmer. Make sure carton is marked for use with LED
compact fluorescent-incandescent light source only. These can be
provided by your local electrical distributor, home center, or hardware
store.
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products.