Installation Sheet
Table Of Contents
FIXTURE INSTALLATION
1. Feed the wire through the STEMS (1) and twist tightly onto the FIXTURE ASSEMBLY (2). Keep adding
additional stems until you desired hanging height is met.
2. Feed the wire through the CONNECTOR(4), CANOPY(3 ) and METAL PAD(10) then secure them to the
STEMS (1) use the HEX NUT(11).
3. Using the MOUNTING PLATE (5) mark holes on the ceiling for the WALL ANCHORS (13), drill holes on the
ceiling and push the WALL ANCHORS (13) into the ceiling.
4. Pull the wire out from the junction box, and install the MOUNTING PLATE (5) onto the junction box using the
MOUNTING SCREWS (6). Screw the WOOD SCREW(12) through the canopy hole into the WALL
ANCHOR(13) .This fixture is designed to be mounted on standard round or octagon junction box. The junction
box must be securely mounted to the structure of the building.
5. Trim off the excess wire to a minimum 6" beyond the STEM and strip each wire
5
8
".
6. Attach the Ground wire (Green) to the ground inside the outlet box (Generally green or bar copper wire) or the
GROUND SCREW (7) on the MOUNTING PLATE (5). NEVER CONNECT GROUND WIRE TO "HOT" WIRE!
FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH!
7. Connect the white fixture lead to the neutral (Generally white) wire in the outlet box. Fasten the wires together
with an approved fastener (WIRE NUT) (8). Starting 1" below the fastener, tightly wrap the connection with
electrical tape so that the connections seals the end of the fastener. MAKE SURE THERE ARE NO EXPOSED
WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT!
8. Connect the black fixture leads to the hot (Generally black) wire in the outlet box. Fasten the joined wires same
as previous step. NEVER REVERSE HOT AND NEUTRAL WIRES. FAILURE TO FOLLOW THIS COULD
RESULT IN SERIOUS INJURY OR DEATH!
9. Push the wires back into the junction box. Lift up the CANOPY (3) up to the ceiling, and secure with the END
NUTS (9).
10. Screw the BULB (14) into the sockets of the fixture.THIS FIXTURE IS RATED FOR 60 WATT LAMP. DO NOT
EXCEED THE RECOMMENDED WATTAGE!
11. Place the GLASS SHADE (15) to the bracket .
12. Restore power to the outlet at the breaker or fuse box.
1
6
5
8
3
9
7
2
4
IRENE
H495905
INSTALLATION INSTRUCTIONS
www.hvlgroup.com
Questions? We're here to help!
Contact us at CustomerService@hvlgroup.com
15
14
10
11
13
12
HUDSON VALLEY LIGHTING
ATTENTION PRUDENCE
· DÉBRANCHEZ L'ALIMENTATION AVANT DE REMPLIR OU DE CÂBLER LE LUMINAIRE. LISEZ
COMPLÈTEMENT TOUTES LES INSTRUCTIONS AVANT DE COMMENCER L'INSTALLATION
· POUR ÉVITER LE RISQUE D'INCENDIE OU D'ÉLECTROCUTION, LE LUMINAIRE DOIT ÊTRE INSTALLÉ
CONFORMÉMENT À TOUS LES CODES ÉLECTRIQUES/DE CONSTRUCTION NATIONAUX ET LOCAUX
APPLICABLES. L'INSTALLATION ET L'ENTRETIEN DE CET APPAREIL DOIVENT ÊTRE EFFECTUÉS PAR UN
ÉLECTRICIEN AGRÉÉ OU UN TECHNICIEN CERTIFIÉ FORMÉ EN USINE.
· CALIFORNIE PROP 65 : CET APPAREIL D'ÉCLAIRAGE CONTIENT DES PRODUITS CHIMIQUES CONNUS PAR
L'ÉTAT DE CALIFORNIE POUR PROVOQUER LE CANCER, DES MALADIES CONGÉNITALES ET/OU D'AUTRES
DOMMAGES À LA REPRODUCTION. LAVER LES MAINS APRÈS UTILISATION.
· RETIRER LE LUMINAIRE, LES PIÈCES ET LE(S) SAC(S) DE PIÈCES DU CARTON. AVANT DE JETER LE
CARTON, VÉRIFIEZ DOUBLE POUR VOUS ASSURER QUE TOUTES LES PIÈCES SONT TROUVÉES.
INSPECTER LE LUMINAIRE AVANT L'INSTALLATION POUR TOUT DOMMAGE AU LUMINAIRE.
· GRADATION : LE LUMINAIRE PEUT ÊTRE CONTRLÉ PAR UN DISPOSITIF DE GRADATION MURALE. UTILISER
UNIQUEMENT UN GRADATEUR TRIAC/ÉLECTRONIQUE. ASSUREZ-VOUS QUE LE CARTON EST MARQUÉ
POUR UNE UTILISATION AVEC UNE SOURCE DE LUMIÈRE FLUORESCENTE À INCANDESCENTE COMPACTE
UNIQUEMENT. CEUX-CI PEUVENT ÊTRE FOURNIS PAR VOTRE DISTRIBUTEUR ÉLECTRIQUE LOCAL,
CENTRE À DOMICILE OU MAGASIN DE QUINCAILLERIE.
· VEUILLEZ NETTOYER UNIQUEMENT AVEC UN CHIFFON DOUX ET SEC ! N'UTILISEZ PAS DE NETTOYANTS
ITEM DESCRIPTION
PART NUMBER
1
HVM STEM KIT (3"+6"+12"+18")X2 STM-H495803,06,12,18
2 FIXTURE ASSEMBLY FAS-H495905
3
CANOPY
CPY-H496905
4 CONNECTOR
CON-H496905
5
MOUNTING PLATE
MPT-H495905
6 MOUNTING SCREW HDW-H495905
7 GROUND SCREW
HDW-H495905
8 WIRE NUT HDW-H495905
9 END NUT HDW-H495905
10
METAL PAD
HDW-H495905
11
HEX NUT HDW-H495905
12 WOOD SCREW
HDW-H495905
13
WALL ANCHOR
HDW-H495905
14
BULB
NOT INCLUDED
15
GLASS SHADE GLS-H495301