Installation Sheet

www.strasserwood.com —
11
— [phone]
Strasser Woodenworks offers two types of tops to complement our vanities: classic granite and quartz with installed under-
mount basins and vitreous china one-piece tops with integral basins. The installation procedure for either is the same.
Keep in mind that all tops are heavy but the stone tops are extremely heavy. Two installers will be required to lift and place
the top!
Ensure that your vanity installation has been completed and that your vanity is properly and solidly shimmed and attached so
that the top edges are level and flat. All bottom edges or legs must be in solid contact with the floor. A low corner or edge
could lead to cracking of the top over time.
Place the top onto sawhorses or other solid support and install your faucet set(s) while you can still easily access the underside.
Then set the top onto the vanity to make sure everything clears. For example, will you be able to connect supply lines? Now is
the time to check! Remove the top and make any modifications to your vanity or structure before proceeding.
Once you are satisfied of the fit and clearances, you are ready to install your top permanently. Remove any dust, dirt and burrs
from the vanity top edges and apply a bead of silicone caulk to all edges that will be in contact with the top. The silicone will
make a flexible support to help distribute weight evenly. Set the top in place, trying to disturb the caulk as little as possible.
CAUTION! Keep your hands and fingers away from the gap under the top as you lower it onto the vanity. Make a
final check for fit and you're finished except for installing backsplash and side splash pieces if being used in your application.
INSTALLING VANITY TOPS .....................................................................................................
Installation