Installation Sheet
Table Of Contents
- ,H326702,
- GENERAL
- INSTALLATION
- STEP 1. Thread the wire through stems and canopy then twist tightly onto body. Keep adding additional stems required.
- STEP 2. Pull the wires out from the outlet box, and install mounting plate onto the outlet box using the (2) mounting screws. Strip the fixture wires ½” long at the ends.
- STEP 3. Trim excess wire to min 6” beyond stem, strip to 5/8” and twist.
- STEP 4. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 5. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 6. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH!
- STEP 7. Carefully place connections back into the outlet box.
- STEP 8. Mount the canopy to the mounting plate and secure with mounting nuts.
- STEP 9. Install the lamps. The fixture is rated for 75 watt type T lamp. DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 10. Attach the glass on the arm use the washers and ball nuts.
- STEP 11. Restore power to the circuit at breaker or fuse box.
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- H326702 B55
- GENERALITÉ
- INSTALLATION
- PAS 5. Relier le fil neutre (blanc) venant de la base du dispositif au fil neutre (généralement blanc) de la boîte de dérivation. Relier les deux fils entre eux à l’aide d’une borne de raccordement en plastique et envelopper celle-ci de ruban isolant ...
- RÈGLAGE D’INTENSITÉ
- NETTOYAGE
- SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
- SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
H326702 ARIEL PENDANT
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
VIS DE MONTAGE
DU CACHE-PITON
BOÎTE DE DÉRIVATION
ABAT-JOUR DE VERRE
PLAQUE DE MONTAGE
VIS DE MONTAGE
RUBAN ISOLANT
CONNECTEUR APPROUVÉ
(BORNE DE RACCORDEMENT)
RONDELLE
PLAFOND
ÉCROU SPHÉRIQUE
ÉCROU DE MONTAGE
AMPOULE
CACHE-PITON