Installation Sheet
Table Of Contents
- ,H326101,H326102,
- GENERAL
- INSTALLATION
- STEP 1. Pull the wires out from the outlet box, and install mounting plate onto the outlet box using the (2) mounting screws.
- STEP 2. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 3. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 4. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH!
- STEP 5. Carefully place connections back into the outlet box.
- STEP 6. Place back plate over the mounting plate and secure with set screws.
- STEP 7. Install the lamp(s). The fixture is rated for 60 watt type T lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 8. Attach the glass on the arm use the washer and ball nut.
- STEP 9. Restore power to the circuit at breaker or fuse box.
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- H326101 B55
H326101, H326102 ARIEL SCONCE
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
VIS DE FIXATION
AMPOULE
BOÎTE DE
DÉRIVATION
PAROI
ABAT-JOUR DE VERRE
VIS DE MONTAGE
PLAQUE DE MONTAGE
VIS DE MISE À TERRE
BAGUE À VISSER
CONNECTEUR APPROUVÉ
(BORNE DE RACCORDEMENT)
RUBAN ISOLANT
PLAQUE ARRIÈRE
ÉCROU SPHÉRIQUE
RONDELLE