Installation Sheet
Table Of Contents
- ,H239301,H239302,H239303,H239304,
- GENERAL
- INSTALLATION
- STEP 1. Pull the wires out from the outlet box, and install mounting plate onto the outlet box using the (2) mounting screws.
- STEP 2. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 3. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 4. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH!
- STEP 5. Carefully place connections back into the outlet box
- STEP 6. Place Back plate over the mounting plate and secure with set screws.
- STEP 7. Put the glass shade(s) onto the glass fitter then secure it with the socket ring.
- STEP 8. Install the lamp(s). The fixture is rated for 35 watt type G9 lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 9. Restore power to the circuit at breaker or fuse box.
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- ,H239301 M43
- GENERALITÉ
- INSTALLATION
- PAS 3. Relier le fil neutre (blanc) venant de la base du dispositif au fil neutre (généralement blanc) de la boîte de dérivation. Relier les deux fils entre eux à l’aide d’un serre-câble en plastique et envelopper le serre-câble de ruban isolant bien ...
- RÈGLAGE D’INTENSITÉ
- NETTOYAGE
- SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
- SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
H239301, H239302, H239303, H239304 RYAN
SCONCE
www.hudsonvalleylighting.com/mitzi| #mymitzi
ASSEMBLY AND MOUNTING DIAGRAM
OUTLET BOX
WALL
MOUNTING PLATE
BACK PLATE
SET SCREW
GROUND SCREW
GLASS SHADE
SOCKET RING
LAMP
GLASS FITTER
FIXTURE MAY ONLY BE INSTALLED AS SHOWN IN PICTURE
WIRE NUT/TAPING DIAGRAM
ELECTRICAL
TAPE
APPROVED
FASTNER
(WIRE NUT)