Installation Sheet
Table Of Contents
- ,H141501S,H141501L,,
- GENERAL
- INSTALLATION
- STEP 1. Pull the wires out from the outlet box, and install mounting plate onto the outlet box using the (2) mounting screws. Strip the fixture wires ½” long at the ends.
- STEP 2. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 3. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 4. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SEROIUS INJURY OR DEATH!
- STEP 5. Carefully place connections back into the outlet box
- STEP 6. Lift Canopy up over the mounting plate and secure with canopy mounting screws.
- STEP 7. Install the lamp(s). The fixture is rated for 60 watt A lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 8. Unscrew Screw checker and slide the glass cover up
- STEP 9. Tilt the glass shade slightly and lift up so the glass support is inside the glass. Straighten out the Glass shade and rest on glass support.
- STEP 10. Slide down the glass cover and screw the screw checker back onto the arm.
- STEP 11. Restore power to the circuit at breaker or fusebox
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- ,H141501,FR
- GENERALITÉ
- INSTALLATION
- PAS 3. Relier le fil neutre (blanc) venant de la base du dispositif au fil neutre (généralement blanc) de la boîte de dérivation. Relier les deux fils entre eux à l’aide d’un serre-câble en plastique et envelopper le serre-câble de ruban isolant bien ...
- RÈGLAGE D’INTENSITÉ
- NETTOYAGE
- SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
- SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
H141501S, H141501L AIRA
FLUSH MOUNT
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
CEILING
MOUNTING PLATE
MOUNTING SCREWS
GROUND SCREW
MOUNTING NUTS
GLASS COVER
GLASS COVER
LAMP
GLASS SHADE
SCREW COLLAR
CANOPY
CANOPY MOUNTING SCREWS
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
RUBAN ISOLANT
CONNECTEUR APPROVÉ
(BORNE DE RACCORDEMENT)
VIS DE MONTAGE DU
CACHE-PITON
PLAQUE DE MONTAGE
VIS DE MONTAGE
BOÎTE DE
DÉRIVATION
PLAFOND
VIS DE MISE À TERRE
ÉCROU DE MONTAGE
CACHE-PITON
AMPOULE
VERRE DE
RECOUVREMENT
ABAT-JOUR DE VERRE
BAGUE DE SERRAGE
VERRE DE RECOUVREMENT