Installation Sheet
Table Of Contents
- ,H139701S,H139701L,
- GENERAL
- INSTALLATION
- STEP 1. Feed the wires through the screw collar, canopy, nipple, and mounting plate until you desired hanging height is met.
- STEP 2. Tie an overhand knot to secure wire in place above the nipple, and trim off excess wire to min 6” beyond the knot. Strip each wire end 5/8”
- STEP 3. Attach the mounting plate to the outlet box using the mounting screws.
- STEP 4. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 5. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 6. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SEROIUS INJURY OR DEATH!
- STEP 7. Carefully place wires into Outlet Box.
- STEP 8. Place the canopy with the fixture over the outlet box and fasten it by the canopy screw collar.
- STEP 9. Install the lamp(s). The fixture is rated for 60 watt G lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 10. Restore power to the circuit at breaker or fusebox.
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- ,H139701,FR
H139701S, H139701L MARNIE
PENDANT
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
OUTLET BOX
CEILING
MOUNTING PLATE
MOUNTING SCREWS
GROUND SCREW
NIPPLE
CANOPY
CANOPY SCREW COLLAR
CORD
WIRE KNOT
LAMP
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
RUBAN ISOLANT
CONNECTEUR APPROVÉ
(BORNE DE RACCORDEMENT)
CORDON
VIS DE MONTAGE
VIS DE MISE À TERRE
CACHE-PITON
AMPOULE
BOÎTE DE
DÉRIVATION
PLAFOND
NOUAGE DU CÂBLE
PLAQUE DE MONTAGE
TÉTON
BAGUE DE SERRAGE
DU CACHE-PITON




