Installation Sheet
Table Of Contents
- ,H122604,
- GENERAL
- INSTALLATION
- STEP 1. Pull the wires out from the outlet box, and install mounting plate onto the outlet box using the (2) mounting screws. Strip the fixture wires ½” long at the ends.
- STEP 2. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 3. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 4. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SEROIUS INJURY OR DEATH!
- STEP 5. Carefully place connections back into the outlet box
- STEP 6. Lift Canopy up over the mounting plate and secure with mounting nuts.
- STEP 7. Install the lamp(s). The fixture is rated for 4 watt LED G9 lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 8. Lift glass shade up and screw onto glass fitter.
- STEP 9. Restore power to the circuit at breaker or fusebox
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- ,H122604 M37,
- GENERALITÉ
- INSTALLATION
- PAS 3. Relier le fil neutre (blanc) venant de la base du dispositif au fil neutre (généralement blanc) de la boîte de dérivation. Relier les deux fils entre eux à l’aide d’un serre-câble en plastique et envelopper le serre-câble de ruban isolant bien ...
- RÈGLAGE D’INTENSITÉ
- NETTOYAGE
- SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
- SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
H122604 ASHLEIGH
FLUSH MOUNT
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
OUTLET BOX
CEILING
MOUNTING PLATE
MOUNTING SCREWS
GROUND SCREW
CANOPY
CANOPY MOUNTING SCREWS
GLASS FITTER
LAMP
GLASS SHADE
MOUNTING NUTS
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
RUBAN ISOLANT
CONNECTEUR APPROVÉ
(BORNE DE RACCORDEMENT)
VIS DE MONTAGE DU CACHE-PITON
PLAQUE DE MONTAGE
VIS DE MONTAGE
BOÎTE DE DÉRIVATION
PLAFOND
VIS DE MISE À TERRE
ABAT-JOUR EN VERRE
CACHE-PITON
AMPOULE
SUPPORT DU VERRE
ÉCROUS DE MONTAGE