Instructions / Assembly
Table Of Contents
- ,H344101,
- GENERAL
- INSTALLATION
- STEP 1. Pull the wires out from the outlet box and install mounting plate onto the outlet box by using the (2) mounting screws.
- STEP 2. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 3. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 4. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SERIOUS INJURY OR DEATH!
- STEP 5. Carefully place connections back into the outlet box
- STEP 6. Place Back plate over the mounting plate and secure with set screws.
- STEP 7. Install the lamp(s). The fixture is rated for 60 watt type A15 lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 8. Tilt and rotate the glass shade so that the glass holder into glass shade. Drop metal cup and secure with the metal ring.
- STEP 9. Restore power to the circuit at breaker or fuse-box.
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- H344 101 B56
H344101 RENEE SCONCE
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
AMPOULE
VIS DE FIXATION
PLAQUE DE MONTAGE
VIS DE MISE À TERRE
CONNECTEUR APPROUVÉ
(BORNE DE RACCORDEMENT)
RUBAN ISOLANT
BORNE DE RACCORDEMENT
PLASTIQUE
VIS DE MONTAGE
BOÎTE DE DÉRIVATION
BAGUE EN MÉTAL
GLOBE DE VERRE
PLAQUE ARRIÈRE
SUPPORT DE VERRE
COIFFE DE VERRE
PAROI