Manualshelf

Instructions / Assembly

ManualsBrandsMitzi by Hudson Valley Lighting ManualsLightingSlater 1-Light Aged Brass Wall Sconce
12
Table Of Contents
FIXTURE INSTALLATION
1. Determine the location for the lamp, Using the FIXTURE ASSEMBLY (5) as a template, mark the location of the holes for
the WALL ANCHORS (3).
2. Drill the appropriate size holes for the WALL ANCHORS (3). ( the holes should be slightly smaller than the size of
the anchors.) Install the WALL ANCHORS (3) to the hole. Attach the MOUNTING PLATE (1) to the WALL
ANCHORS (3) and secure them with WOOD SCREW (2).
3. Place the FIXTURE ASSEMBLY (5) over the MOUNTING PLATE (1) and secure with SET SCREW (4).
4. Screw the BULB (6) up into the SOCKET of the fixture.THIS FIXTURE IS RATED FOR 60 WATT LAMP. DO
NOT EXCEED THE RECOMMENDED WATTAGE!
5. Plug cord into a qualified socket of properly rated voltage, On/Off switch installed on socket.
ITEM DESCRIPTION
PART NUMBER
1
MOUNTING PLATE
HDW-HL491201
2
WOOD SCREW HDW-HL491201
3
ANCHOR
HDW-HL491201
4
SET SCREW
HDW-HL491201
5
FIXTURE ASSEMBLY FAS-HL491201
6
BULB
NOT INCLUDED
SLATER
HL491201
INSTALLATION INSTRUCTIONS
www.hvlgroup.com
Questions? We're here to help!
Contact us at CustomerService@hvlgroup.com
6
3
2
4
5
1
WARNING/CAUTION
· DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS
COMPLETELY BEFORE STARTING INSTALLATION.
· TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. THE INSTALLATION AND
MAINTENANCE OF THIS UNIT SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN OR CERTIFIED
FACTORY TRAINED TECHNICIAN.
· CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS
AFTER USE.
· REMOVE THE FIXTURE, PARTS AND PARTS BAG(S) FROM THE CARTON. BEFORE DISCARDING THE
CARTON, DOUBLE CHECK TO MAKE CERTAIN THAT ALL PARTS ARE FOUND. INSPECT THE FIXTURE PRIOR
TO INSTALLATION FOR ANY DAMAGE TO THE FIXTURE.
· DIMMING: THE FIXTURE CAN BE CONTROLLED BY A WALL DIMMING DEVICE. ONLY USE
TRIAC/ELECTRONIC DIMMER. MAKE SURE THE CARTON IS MARKED FOR USE WITH LED COMPACT
FLUORESCENT-INCANDESCENT LIGHT SOURCE ONLY. THESE CAN BE PROVIDED BY YOUR LOCAL
ELECTRICAL DISTRIBUTOR, HOME CENTER, OR HARDWARE STORE.
· PLEASE CLEAN WITH A SOFT, DRY CLOTH ONLY! DO NOT USE CLEANSERS
HUDSON VALLEY LIGHTING

Summary of content (2 pages)