picoPSU-120-WI-25 12-25V, 120Watt ATX Power Supply Quick Installation Guide Version 1.
ATX DC-DC Converter Series Introduction The picoPSU-120-WI-25 is a small yet powerful and fully compliant ATX power supply designed to power a wide variety of motherboard from a single 12-25V unregulated power source. The picoPSU-120-WI-25 is the only “plug-in” wide input range power supply solution for general purpose low power motherboards. Compatible with most VIA C3/C7 CPUs M/B and with Pentium-M / Core Duo boards, picoPSU-120-WI-25 provides cool, 100% silent power for your system.
ATX DC-DC Converter Series 2) Connect a 12-25VDC power adapter (peak should not exceed 26.5V) to the input connector. 3) Turn on the PC using the motherboard ON/OFF switch Typical configuration The picoPSU-120-WI-25 has been tested with all mini-ITX board under virtually any disk/floppy/CDROM/PCI configuration. Removing the picoPSU-120-WI-25 In order to remove the picoPSU you must release the power connector latch and then remove the unit.
ATX DC-DC Converter Series Input Requirements: 12-25V un-regulated, min=2A, max=10A (load dependent). Max Input Voltage supported by TVS clamp=26.5V. NOTE: Above 26.5V, the TVS protection diode will clamp and burn the input fuse. Size: 44.5mm(L) * 20mm(W) * 30mm (H) (1U compliant) Weight: 70gramms, including cable harness, 35 grams without cable harness. DC-Jack: Female, panel mount, 2.5*5.5*10 mm. Connectors Molex 39-01-2200, two 3.5” drive power connector, 1 floppy.
