User guide

\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL
READOUT.doc Rev. 2.00 11/17/04 JEP
- 2 -
STEP #5 INSTALL 1/4-20 SHCS
AND WASHER THRU ACCESS
HOLE IN SIDE OD TUBE INTO
STEP #4 SLIDE BRACKET SLOT IN THE ALUM BRACKET.
OVER TOP OF GEAR RACK. DO NOT TIGHTEN!
STEP #7 SET DIGITAL
READOUT SCALE ON TOP
STEP #6 SET THE 2 ALUM OF ALUM SPACERS WHILE
SPACERS ON TOP OF TUBE ALIGNING THE 1/8 DIA PIN
OVER THE 10-32 TAPED WITH THE DRIVE SLOT ON
HOLES. THE BRACKET.
1-800-467-2464
2500-501
2500-021