User guide

\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL

READOUT.doc Rev. 2.00 11/17/04 JEP

- 1 -

ASSEMBLY INSTRUCTIONS FOR

DIGITAL READOUT

DISASSEMBLE READOUT & GUARD FROM TUBE

STEP #1 PLACE STEEL

TUBE OVER GEAR RACK.

STEP #2 INSTALL 4 1/4-20 STEP #3 INSTALL ALUMINUM

SHCS AND TIGHTEN DOWN. BRACKET THRU TOP OF SLOT.

1-800-467-2464

2500-020

2500-019

2500-021

2500-020

2500-501

PAGE 1
-1- ASSEMBLY INSTRUCTIONS FOR DIGITAL READOUT DISASSEMBLE READOUT & GUARD FROM TUBE STEP #1 2500-019 PLACE STEEL TUBE OVER GEAR RACK. 2500-020 2500-021 2500-501 2500-019 STEP #2 INSTALL 4 1/4-20 SHCS AND TIGHTEN DOWN. STEP #3 INSTALL ALUMINUM BRACKET THRU TOP OF SLOT. 2500-020 1-800-467-2464 \\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL READOUT.doc Rev. 2.
PAGE 2
-2- STEP #4 SLIDE BRACKET OVER TOP OF GEAR RACK. STEP #5 INSTALL 1/4-20 SHCS AND WASHER THRU ACCESS HOLE IN SIDE OD TUBE INTO SLOT IN THE ALUM BRACKET. DO NOT TIGHTEN! STEP #6 SET THE 2 ALUM SPACERS ON TOP OF TUBE OVER THE 10-32 TAPED HOLES. STEP #7 SET DIGITAL READOUT SCALE ON TOP OF ALUM SPACERS WHILE ALIGNING THE 1/8 DIA PIN WITH THE DRIVE SLOT ON THE BRACKET.
PAGE 3
-3- STEP #8 TIGHTEN DOWN THE 2 10-32 SHCS THAT MOUNT THE SCALE. STEP #9 SLIDE READER HEAD TOWARD MACHINE UNTIL IT STOPS. THEN TIGHTEN DOWN THE 1/4-20 SHCS THRU ACCESS HOLE ON THE SIDE OF THE TUBE. STEP #10 INSTALL THE COVER-GUARD OVER DIGITAL READOUT WITH 6 1/4-20 BSHCS AND WASHERS. 1-800-467-2464 \\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL READOUT.doc Rev. 2.