Owner's manual

- 7 -
OPERATION
1. Insert tubing into channel in the shoe, follow bar, and
adjustable saddle.
CAUTION: Be sure roller pin is completely through lower
frame
2. Align the bend start point marked on tubing to the bend start
point on the bender shoe.
3. Make sure that tubing is sticking all the way through the adjustable
saddle.
4. Tighten adjustable saddle ”V” block against tubing.
CAUTION: Be sure pin is completely through bottom saddle arm.
5. Align the front edge of the follow bar with the bend start point of the bending shoe.
6. Press the foot pedal on the hydraulic pump, using short bursts until the bending shoe and follow
bar are close to the roller.
7. Check your tubing to make sure that your tubing start point is still aligned with the shoe start point.
8. Now make your bend by pressing down on the foot pedal heel on the hydraulic unit until the
desired angle is reached.
9. It usually is necessary to bend tubing past the desired angle a few degrees to account for tubing
spring back. Note: Record location of reference scale pointer to reference scale to assist in
completing future bends to same degree of bend with same tubing material, size, and wall
thickness. Then you can bend the next pieces to that same reference scale mark.
10. When desired angle is reached, press hydraulic pump foot pedal toe to release pressure.
11. Turn adjustable saddle knob counterclockwise to remove saddle pin, saddle and follow bar.
12. Repeat these steps with each additional bend.
#2 Bend Start Point
#3 Tubing Through the Saddle
#4 Roller
Male
Hydraulic
Coupler
#9 Release
Pressure
#4 & #7
Pump
Pressure
AIR / HYDRAULIC PUMP
#5 Shoe Start Point
#8 Reference Scale
#10 Follow Bar
#10 Saddle
#10 Saddle Pin