Instruction Manual

\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\manual\2500 Owners Manual.doc REV.3 11-29-06
- 5 -
GETTING READY TO BEND
1. Slide the main Bender Shoe over the Square Drive Shaft. Be sure that the
MB and
START are facing up and that they are positioned as shown above. The START
engraving should be closest to the Pressure Roller Assembly.
2. Position the Pressure Roller Assembly to the correct position by loosening and
removing the two Allen Head Bolts. Once this correctly positioned reinstall the bolts and
tighten. Be sure that the Pressure Roller Adjusting Shaft turns freely while tightening.
Square Drive Shaft
Rotation Direction
U Saddle & Pin Assembly or
Adjustable Saddle Assembly
Pressure Roller
Assembly
Follow Bar
Pressure Roller
Assembly
Start Mark
Pressure Roller
Mounting Block
Pressure Roller
Adjusting Shaft
Bender Shoe