Installation manual

Part 3. Installing the UDF Reader

Step 1. Select UDF Reader. When you do this “Adaptec Setup

Wizard dialogue box will pop-up and display the follwing

questions:

“This Setup wizard installs the Adaptec Direct CD (UDF) Reader for

window 95/ Window NT. Do you wish to continue?”

Set 2. Select “Yes” to install the UDF raeder software

Set 3. At the next screen choose the language you prefer and then

choose the “Next>” button

Set 4. Now click on the “Install” button to load the software

Set 5. Then click on “Exit” at the “Master Setup” window

Set 6. The “Setup Complete” window pops up and asks if you wish

to restart your system now; the default is yes

Set 7. Choose the “Finish” button to exit the setup wizard

Part 4. Installing the USB drivers

Step 1. Power up your PC and verify that the system has booted up

and the Windows Operating System Desktop is loaded.

Step 2. Switch the power on at the rear of the Que! USB Drive. When

you do this the operating system should detect the Que! USB

Drive and start the “Add New Hardware Wizard”.

Step 3. Insert the Que! installation CD in your system’s CD-ROM drive.

Step 4. Immediately after you power on your Que! USB Drive

Windows 98 will display the “New Hardware Found” window

and then automatically display the “Add New Hardware

Wizard” window.

Step 5. Press the “Next>” button.

PC Installation