Specifications

www.m16canz.com
10
8. Click the BPR button to perform Blank Check, Program and Read Check on the specified address
range (0FE000 to 0FFFFF) for the monitor program.
9. After the BPR operation is completed, exit the Flash Start program by clicking the Exit button.
10. Remove power on the SK board and remove the CNVss jumper.
11. Reapply power to the SK board. The SK board should now operate in normal mode. With the
monitor program now in place it should be able to communicate with KD30 Remote Debugger.
KD30 Debugging
1. Go to TM Project Bar and click the Debug button.