Operating instructions

Using the remote control to operate VCRs, cable boxes

and other equipment (cont.)

setting up the remote control to operate other brands of equipment.

O Tam on your VCR, Cable Box or o_her eqalpmem.

0 Se_ the select switch on the remo_e to the layer yon wan_ to set ap:

VCR or DVDiCABLE or AUDIO.

@ While holding in the POWER key on the remo_e control, enter _he code

number lis_ed for your brand of eqaipment. The code number can be

found in the charts following _hese ins_ructlons. Be sure to enter both

digits of the code number. If more than one code number is listed, start

wi_h the firs_ code number.

Release _he POWER key, poin_ the remo_e at _he equipmen_ you are

t_-ing _o set up the remote _o control and press the POWER key again.

If _he eqaipmen_ turned off. the remo_e is ready _o control _hat eqaip-

men_. If the equipment did no_ turn off, repea_ the instructions using

the nex_ code listed for _hat brand.

O If none of the code numbers listed for _hat brand of equipment seems to

work, try all of the codes for _he eqaipmen_ _-pe. For VCR's try codes

01 to 21. For Cable Boxes and Satellite Receivers _- codes 47-99.

To rese_ an individual layer to its initial setting, follow t:he setup

instructions and use 00 as the code number.

Important:

[_>Important:

Aider se_ing up your remote control, if you canno_ turn on t:he

cable box by pressing POWER, _ry using _he CHANNEL bu_ton or

number buttons. Some cable boxes will turn on when a channel is

requested.

Sometimes manufacturers will change their produc_% or they may

use more than one remote control system. If _his is the case, your

remo_e may no_ be able _o operate your VCR, Cable Box or Satellite

Receiver.

When you replace _he ba_eries in your remote control, _he remote

will usually return to its initial setting. You may need to set up

your remo_e again.

_i_--;:. If you are using TV GUIDE Plus _, do not turn the cable box off'. Always leave I

the cable box on.

Overview of t:he Remo_e Control 23