Manual

Ap pe n d i E Dia m o n d S h ie!d ! nst ru c tio ns

Diamond Shield TMInstallation for Models WS-48511,

WS- 55711, WS-65711, WS-65712 and WS-73711

I.IJ

The instructions below will lead you through the

Diamond Shield installation process.

Included in the Diamond Shield package are the

following items:

For models WS-65711, WS-65712 and

WS-73711 only.

(1) Diamond Shield TM

(2) molding clips

1. Carefully remove the Diamond Shield TM from

the protective packaging. Wipe off any dust with a

lint-free cloth. Do not use any cleaners on the anti-

glare Diamond Shield TM.

2. Begin by inserting the shield, sliding it into the

channels, starting at the bottom. Gently bow the

Diamond Shield TM toward you and insert the top of

the Diamond Shield TM into the top channel.

3. Install the left and right molding clips by pressing

them into the opening, starting at a corner.

Do not force the clip. The clip will slide

into place. This completes the Diamond

Shield TM installation.

To remove the Diamond Shield TM, reverse

the order of the above process.

Diamond Shield TM for the models WS-

48511 and WS-55711 comes installed by

the factory.