Manual

Appendix E: Diamond Shield Instructions

Diamond Shield TM Installation

for Models WS-B55, WS-55511, WS-65511 and WS-65611

The instructions below will lead you through the

Diamond Shield installation process.

Included in the Diamond Shield package are the

following items:

For model WS-655tl and WS-65611 only.

(1) Diamond Shield TM

(2) molding clips

1. Carefully remove the Diamond Shield TM from

its protective packaging. Wipe off any dust with a

lint-free cloth.

2. Begin by inserting the shield, sliding it into the

channels, starting at one side. Gently bow the

Diamond Shield TM toward you and insert the side

of the Diamond Shield TM into side channel then

install the opposite side.

3. Install the top and bottom molding clips

by pressing them into the opening, starting

at a corner. Do not force the clip. The clip

will slide into place. This completes the

Diamond Shield TM installation.

To remove the Diamond Shield TM, reverse the

order of the above process.

Diamond Shield TM for the models WS-B55 and

WS-55511 comes installed by the factory.

.m.