Manual

Programming the Remote Control to Control Non-NetCommand TM
AV Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(Figures 1-5)
1. Move the slide switch at the top of the
remote to the product you want to control.
2. Press and hold the POWER button on the
remote control.
3. Enter the first three digit code listed for
your equipment, and then release the POWER
button on the remote control.
4. Point the remote control at the equipment
and press the POWER button. If the equipment
responds, the remote control is properly
programmed to operate the equipment. If the
equipment does not respond, repeat steps 2-4
with the next three digit code listed in step 3 for
your equipment.
POWER
&
Cable box brand
General Instruments/
Jerrold/Motorola
Oak
Pioneer
Scientific Atlanta
Zenith
Code_enten
111_119_120_121_122_
123,124,125,126,127
102,137,139
101,116
111_112_113
100,117
To reset to default code, enter 000
If your
cable box
code is not
listed here,
please see
page 74
for a
complete
listing.
Figure 1. Programming the remote to control your cable
box.
POWER
Satellite brand Codeto enter:
Mitsubishi DTV - DBS 006
Echostar)Dishnetwork 175
Hughes - DBS 173
RCA - DBS 176
Sony - DBS 177
Toshiba - DBS 173
Panasonic - DBS 174
To reset to default code, enter 000
If your
satellite
receiver
code is not
listed here,
}lease see
page 74
for a
complete
listing.
Figure 2. Programming the remote to control your
satellite receiver.
POWER
VCR brand
Mitsubishi
Hitachi
JVC
PhiIlips / Magnivox
Panasonic
RCA
Sony
Toshiba
Codeto enter:
001,002
020_ 043_ 065
030, 054, 059
043, 044, 051
041,042, 043
020, 053, 065
048, 049, 050
021,066
To reset to default code, enter 000
If your
VCR
code is not
listed here,
)lease see
page 74
for a
complete
listing.
Figure& Programming the remote to control your VCR.
67