Manual

Programming the Remote Control to Control NetCommand TM A/V
Products
To Program the Remote to Control
NetCommand TM A/V Products:
(See NetCommand Supported Devices, for the list
of A/V products supported by the NetCommand TM
System.)
1. Move the slide switch at the top of the
remote to the TV layer.
NetCommand TM CODE to ENTER
TV Control and NetCommand TM 935
Dev ces:
TV
POWER
_," Ollll,II _ l Ol':
2. Press and hold the POWER button on the
remote control.
Figure 1. Programming the TV remote to control your
NetCommand TM A/V devices.
3. Enter the three digit code of 935, and then
release the POWER button on the remote
control.
4. The remote control is now programmed to
send NetCommand TM signals to the TV so
the TV can control the IEEE 1394 devices and
selected older NetCommand TM supported IR
devices. See the NetCommand TM guide for
details.