Manual

NetCommand TM Setup
When you first power On your new Mitsubishi TV, the initial setup screens will appear. You will need to
navigate through these screens and properly set up the equipment connected to the TV in order to use
NetCommand TM.
NetCommand TM supports the automatic switching of audio and video inputs using only the TV Remote
Control.
IMPORTANT
_IUi _ay use your TV without setting up NetCommand TM. You may also
_t_ NetCommand TM at a later time by choosing Setup from the Main
then select Edit NetCommand TM.
Language Screen
Figure 1
The Language screen is the initial menu displayed
the first time the TV is turned On. You will need to
select the language you would like to use. When
you change your selection from English to Spanish,
all screens automatically change to Spanish. To
change Language later, go to Setup in the Main
Menu.
Information Screen
Figure 2
The Information Screen describes hew to proceed with
or cancel the initial NetCemmand TM Setup.
NetCommand TM Setup is initialized automatically the first
time you power On your new TV. If, for any reason, your
NetCommand TM Setup is cancelled before completing,
follow the steps below to start NetCommand TM setup
later.
1. Display the TV Main menu.
2. Select the Setup menu.
3. Select the Edit NetCommand TM option in the Setup
menu.
4. Select Initial on the Edit NetCommand TM menu
Result: The AV Receiver screen displays.
28
Figure 1. Setup-Language screen.
Figure 2. NetCommand TM Info screen.