Manual

Programming the Remote Control to Control NetCommand TM
NetCommand TM CODE to ENTER] TO Program the Remote to Control
TV Control and NetCommand TM 9351 the TV and NetCommand TM A/V
Products:
Dev ces:
TV
POWER
_," Olllldl _ j Ol
Figure 1. Programming the TV remote to control your
NetCommand TM A/V devices.
(See NetCommand TM Supported Devices, for the list
of A/V products supported by the NetCommand TM
System.)
1. Move the slide switch at the top of the
remote to the TV layer.
2. Press and hold the POWER button on the
remote control.
3. Enter the three digit code of 935, and then
release the POWER button on the remote
control.
4. The remote control is now programmed to
send NetCommand TM signals to the TV. The
TV can also control the IEEE 1394 devices
and selected NetCommand TM supported IR
devices. See the NetCommand TM guide for
details.