Operating instructions

13
13
1 2
3
4 5
6
7
Y
G
Pb
B
Pr
R
V
H
HIGH RESOLUTION INPUT
INPUT
3 PIP
S-VIDEO
COMPONENT
480i /480p
1 (YPrPb)
2 (YPrPb)
DTV (YPrPb/GRBHV)
480i /480p / 1080i
VIDEO
MONITOR
ACTIVE A/V
NETWORK
IR - HOME
THEATER
21
OUTPUT
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
ANT-BLOOP OUTANT-A
Part II: Installation
Back Panel Functions
Back Panel
1
Inputs 1-3
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, laser disc
player, or other A/V device to the TV. Please note that with each input, you may connect to
the S-VIDEO or VIDEO terminal, but not both.
2
Output (Monitor and PIP)
The Monitor Output sends the TV audio and video signals, excluding component video or
DTV, to an A/V receiver or other equipment. The PIP output sends the PIP’s or POP’s
audio signal to an amplier or wireless headphones. If no PIP or POP is displayed, the PIP
output will send the main picture audio signal.
3
Antenna (ANT-A, LOOP OUT, and ANT-B)
ANT-A and ANT-B receive signals from VHF/UHF antennas or a cable system. LOOP OUT
sends the ANT-A signal out to another component, such as a cable box or VCR.
4
Active A/V Network
This interface connects Mitsubishi products that have an A/V network terminal.
5
IR Home Theater
Connecting an IR emitter here allows the TV to automatically change a Mitsubishi digital
A/V receiver’s input in a home theater setup.
6
Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video
outputs, such as a DVD player. Please see Appendix B, page 65, for signal compatibility.
7
DTV Input
This input is used to connect a DTV receiver, and can be congured for HDTV component,
RGB, and RGB pluss H&V. Please see Appendix B, page 65, for signal compatibility.