Manual

Part II1: Setup
Use of the Remote Control with Other A/V Products
[]
POWER
E
DVD/LDP brand Codeto enter:
Mitsubishi (DVD) 003
Mitsubishi (LDP) 016,017
Panasonic 250
Pioneer DVD (LDP) 252 (016, 017)
Sony 254
Toshiba 253
To reset to default code, enter 000
If your
DVD
code Jsnot
listed here,
please see
page 66
fora
complete
listing.
Figure 4. Programming the remote to control your DVD/
LDP.
[]
TV
POWER
E
Audio brand
Mitsubishi A/V receiver
and/or CD player
Kenweod
Onkyo
Pioneer
Sony
Yamaha
Code to enter:
010,011
200,208
209,214
205,207
222
201,208
To reset to default code, enter 000
If your
audio
code is not
listed here,
please see
page 66
fora
complete
listing.
Figure 5. Programming the remote to control your A/V
receive_
After entering the correct codes in each posi-
tion of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If
you enter a code frome the AUDIO chart
while the slide switch is set to TV, the
volume and mute functions change to match
the A/V receiver. This is useful when using
an A/V receiver with the TV all the time.
Only one device is allowed for each slide
switch position, however, selected
TV position:
_TV
[] A/V receiver (volume and mute only)
Cable/DBS/DTV position:
[] Cable box
[] Satellite receiver
[] DTV receiver
VCR position:
[] VCR
DVD position:
[] DVD
[] VCR
[] LD Player
Audio position:
[] A/V receiver
[] Mitsubishi CD player (if youhavea MitsubishiA/V
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet an the back of your A/V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF Play Rew etc.) in the audio position will
opera e the CD player.)