Manual

Part II1: Setup
Use of the Remote Control with Other A/V Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(Figures 1-5)
[] Move the slide switch at the top of
the remote to the product you want to
control.
[] Press and hold the POWER button on
the remote control.
[] Enter the first three digit code listed for
your equipment, and then release the
POWER button on the remote control.
[] Point the remote control at the equip-
ment and press the POWER button.
If the equipment responds, the remote
control is properly programmed to oper-
ate the equipment. If the equipment
does not respond, repeat steps 2-4 with
the next three digit code listed in step 3
for your equipment.
[]
TV
POWER
Satellite brand
Mitsubishi DTV - DB:
Dishnetwork
Hughes - DBS
RCA - DBS
Sony - DBS
Toshiba - DBS
Panasonic - DBS
Primestar
Codetoenter:
006
175
173
176
177
170
174
178
To reset to default code, enter 000
If your
satellite
receiver
code is not
listed here,
)lease see
page 66
fora
complete
listing,
Figure 2. Programming the remote to control your satel-
lite receive_
T ',_ 1I I Ir AUDIO / \
[] _ : II @ []
E
[__
Cable box brand
General Instruments/
Jerrold
Oak
Pioneer
Scientific Atlanta
Zenith
Codetoenter:
111,119, 120, 121,122,
123,124,125,126,127
102,137,139
101,116
111,112,113
100,117
To reset to default code, enter 000
Ifyour
cable box
code is net
listed here,
please see
page 66
fora
complete
listing.
Figure 1. Programming the remote to controlyour cable
box.
[]
°/_V
POWER
VCR brand
Mitsubishi
Hitachi
JVC
Phillips / Magnivox
Panasonic
RCA
Sony
Toshiba
Codetoen_r:
001,002
020, 043,065
030,054,059
043, 044, 051
041,042,043
020, 053_065
048, 049, 050
021,066
To reset to default code, enter 000
If your
VCR
code is not
listed here,
)lease see
page 66
for a
complete
listing.
Figure 3. Programming the remote to control your VCR.