Manual

Part I1: Installation
Connecting a VCR
TVb_kpsnel
mm
Antennas or Wall Outlet Cable
(Figure 1)
[] Connect the incoming cable to ANT-A on
the TV back panel.
[] Connect two coaxial cables as follows:
[] One from LOOP-OUT on the TV back panel to
ANTENNA IN on the VCR back panel.
[] One from VCR back panel ANTENNA OUT to
ANT-B on the TV back panel.
Figure 1. Connecting VCR with antennas or wall outlet
cable. Cable Box
(Figure 2)
_ba_kp_n_l
mm
[] Connect the incoming cable to ANT-A on
the TV back panel.
[] Connect three coaxial cables as follows:
[] One from LOOP-OUT on the TV back panel to
IN on the back of the cable box.
[] One from OUT on the back of the cable box to
ANTENNA IN on the VCR back panel.
[] One from ANTENNA OUT on the VCR back
panel to ANT-B on the TV back panel.
Composite Video with Audio or
S-Video with Audio
(Figure 3)
Figure 2. Connecting VCR with cable box.
_a
[] Connect a video cable from VIDEO
OUT on the VCR back panel to VIDEO
INPUT-1 or INPUT-2 on the TV back
panel.
[] If you have a S-VHS VCR, follow the same
steps using the S-Video terminals on the VCR
and TV (in place of the composite terminals).
[] Connect a set of audio cables from
AUDIO OUT on the VCR back panel to
AUDIO INPUT-l, INPUT-2, or INPUT-3
on the TV back panel. The red cable
connects to the R (right) channel and
the white cable connects to the L (left)
channel. If your VCR is mono (non-ste-
reo), connect only the white (left) cable.
Figure 3. Connecting the VCR Audio/Video.