Manual

Programming the Remote Control to Control Non-NetCommand TM
A/V Products After entering the correct codes in each position of
POWER
g Tv NC)
Fi
DVD/LDP brand if your
Mitsubishi (DVD) DVD
Mitsubishi (LDP) code is not
Panasonic listed here,
Pioneer DVD (LDP) please see
Sony page 74
for a
Toshiba complete
TO reset to default code, enter 0O0 listing.
Codetoenter:
003
016, 017
250
252 (016, 017)
254
253
_ure 4. Programming the remote to control your DVD/
LDP.
the remote control, use the slide switch to select
which product will respond when an operational
button is pressed. If the TV position has not been
programmed to control NetCommand TM and you
enter a code from the A/V Receiver chart while
the slide switch is set to TV, the volume and mute
functions change to match the A/V receiver. This
is useful when using an A/V receiver with the TV all
the time. In all other cases, only one of the below
devices is allowed for each slide switch position.
TV position (when the remote has not been
programmed to operate NetCommandZM):
[] TV
[] A/V receiver (volume and mute only)
Cable/DBS/DTV position:
[] Cable box
[] Satellite receiver
[] DTV receiver
POWER
Audiobrand
MitsubishiNV receiver
and/orCDplayer
Oenon
Kenwood
JVC
Onkyo
Pioneer
Sony
Yamaha
Codeto enter:
ot0
234, 235, 236
200, 208
232_ 233
209, 214
205, 207
222
201,202
To reset to default code, enter 000
If your
audio
code is not
listed here,
please see
page 74
for a
complete
listing.
VCR position:
[] VCR [] DVD [] LD Player
DVD position:
[] DVD
[] Cable box
[] LD Player
[] VCR
Audio position:
[] A/V receiver [] Cable box
[] Mitsubishi CD player [if youhaveaMitsubisHA/V
receiver, the audio position may be used in conjunction with
selected Mitsubishi CD players. Your audio position must be
programmed to 010 ].
Figure 5. Programming the remote to control your A/V
receive_
IMPORTANT
If the remote control has not been
programmed to operate NetCommand TM
and slide switch is set to TV when you
enter an A/V receiver code, VOLUME and
MUTE will control the A/V receiver rather
than the TV. To return volume and mute
control to the TV, set the slide switch
to TV, press and hold POWER and enter
000.
IMPORTANT
manufacturers may change their
or they may use more than
If this is the
not be
ible to operate your VCR, DVD, cable
satellite receiver, or A/V receiver.
iiiii
68