Manual

Edit NetCommand TM, cont'd.
Figure 1. Delete screen.
Figure 2. Review screen.
Figure 3 Edit NetCommand TM (Initial) screen
Delete
Figure 1
When you select Delete from the Edit
NetCommand TM Screen, you will see the Delete
Screen. You can choose to delete just a single
device by selecting the device you would like to
delete, or you can delete the entire NetCommand TM
configuration. After you have chosen the device,
or the Entire Configuration, you will be prompted
to confirm your choice to delete. If you select the
Entire Configuration, the Initial button becomes
available on the Edit NetCommand TM screen.
Review
Figure 2
When you select Review from the Edit
NetCommand TM Screen, you will see the Review
Screen. This is the same Review Screen from the
Initial Setup.
On this screen, adding or deleting check marks will
turn On or Off the adjacent Input or Device.
Initial
Figure 3
If, for any reason, you cancelled out of the Initial
Setup before completion, or if you deleted the
entire configuration, select Initial from the Edit
NetCommand TM Screen to go through initial setup
again, starting with the A/V Receiver screen.
33 TM