Manual

3
Connecting a DVD Player
IMPORTANT
, See Appendix B for component
=gnal compatibility information.
, For digital audio connections, see
DVD, and Satellite
Receiver Owner's Guides.
Connecting an S-Video
Satellite Receiver
Tv _k panal
g_m
Figure 2. Connecting an S-Video Device.
DVD Player with Component Video
(Figure 1)
1. Connect the Component Video cables from Y/
Cr/Cb or Y/Pr/Pb VIDEO OUT on the back of the
DVD player to COMPONENT-1 on the TV back
panel, matching the correct connection:
• YtoY
• CrorPrtoPr
• CborPbtoPb
2. Connect a set of audio cables from
AUDIO OUT on the back of the DVD player to
COMPONENT-1 AUDIO Input on the TV back
panel. The red cable connects to the R (right)
channel, and the white cable connects to the L
(left) channel.
Important: If you add a second DVD or use
any other inputs for your DVD, see the section
on Editing NetCommand TM Setup to ensure
this change is matched by the NetCommand TM
system.
S-Video Satellite Receiver
(Figure 2)
1. Connect an S-Video cable from VIDEO OUT
on the satellite receiver back panel to VIDEO
INPUT-2 on the TV back panel.
2. Connect a set of audio cables from AUDIO
OUT on the satellite receiver back panel to the
AUDIO INPUT-2, on the TV back panel. The
red cable connects to the R (right) channel and
the white cable connects to the L (left) channel.
Note: Refer to the Satellite Receiver Owner's
Guide for Dish Antenna connections.
Important: If you add a second Satellite
Receiver or use any other inputs for your
Satellite Receiver, see the section on Editing
NetCommand TM Setup to ensure this change is
matched by the NetCommand TM system.