User manual

30 03/2013-00
KNX | InSideControl App/HD App
InSideControl App / HD App
Settings
Demo
Demo Mode
If this option is selected, the App/HD App is put into Demo Mode.
In Demo Mode, you can test the behaviour of the App/HD App without being connected to a
KNX installation.
Pre-set rooms and devices are shown, which represent a conventional KNX installation. All
symbols and buttons react in the same way as with a connected KNX installation.
The Demo Mode is always active if no conguration le has been loaded. The Demo Mode
can be deactivated only when a conguration le is loaded. The status report in the status
bar shows whether the App/HD App is in Demo Mode.
Connection settings
The exact procedure for connecting the portable device to the IP gateway is outlined in this
chapter: Connecting portable devices to the IP gateway --> 11
Application status
The application status shows whether InSideControl is working correctly. The MAC address
with which a connection is to be established is also shown.
Autodiscover
If this option is selected, the App/HD App will search for valid IP gateways in the local
network. This means that the IP address and the port of the IP gateway do not have to be
entered manually.
If the IP gateway is discovered, the App/HD App connects automatically.
We recommend that the IP address and the port be entered manually if there is more than
one IP gateway or other KNX netIP devices in your LAN.
IP Address
Enter the IP address of your IP gateway here.
The IP gateway must be assigned a xed IP address in the network.
Port
Enter the port for your IP gateway here. The standard port address is: 3671