User manual

20 03/2013-00
KNX | InSideControl App/HD App
InSideControl App / HD App
Meaning of the symbols
Device symbols
A device symbol represents a connection to one or more devices of your KNX installation.
The appearance and operating mode of a device symbol depend on the connected device.
A Device name
B Result of the status query
C Symbol of the device
The status query
To ensure that the current device status is always shown in the App/HD App, InSideControl
queries the device status at dierent points in time. These points in time are:
• When the App/HD App is started: All devices are queried.
• When a room is called up: All devices of the room are queried.
• When the device name is tapped.
The status query and update may take several seconds depending on the scope of the pro-
ject and the quality of the connection.
The success or failure of the status query is shown in the App/HD App with two symbols next
to the device name:
The status query was successful, the status is known. The device can be
controlled.
The status query was unsuccessful, the status is unknown. The device
cannot be controlled.
To rectify the error:
1 Tap on the device name and connect again.
2 If no connection can be established, contact your system integrator.
Below, you will nd an overview of the device symbols and their relevant options.
Lighting
This device symbol represents a light. The device symbol shows the status of the light.
Switching the light on or off
1 Tap on the device symbol to switch the light on or o.