User manual
1103/2013-00
InSideControl App/HD App | KNX
InSideControl App / HD App
Setting up InSideControl
Connecting portable devices to the IP gateway
To access your KNX installation with the App/HD App, an IP gateway (art. no. xxx6500-0113)
must be installed in your KNX installation. The IP address of the IP gateway can be assigned
via a DHCP server or via manual conguration as an ETS parameter. The exact procedure
can be found in the software application for the IP gateway.
There are two ways to access the KNX installation via the IP gateway:
• WLAN access
• VPN access
WLAN access
For WLAN access, the IP gateway and the portable device are in the same network (WLAN).
To control the KNX installation, the IP address/port of the IP gateway must be known to the
portable device.
You can establish the connection either automatically or manually.
Establishing an automatic connection
If one IP gateway is available in your KNX installation or no xed IP address is assigned to
the IP gateway, the connection should be discovered automatically.
1 Open Settings (see Settings --> 29).
2 Deactivate the Demo mode option.
3 Activate the Autodiscover option.
⇒ The IP gateway is searched for in the
network.
If an IP gateway is found, the App/HD App
connects automatically.
Autodiscover
Enable this option to automatically dis-
cover your IP gateway IP address.
IP address
No valid IP address
Port
No valid port
Demo mode
Enable this option to use the demo
mode of the application.