Manual

52 6. NetCommand Control of an A/V Receiver (837 Series)
Power and Volume
Perform this setup to control the A/V receiver power
and volume with the TV's remote control.
To perform this setup you need:
• The remote controls for both the TV and the
A/V receiver.
An IR emitter cable available from Mitsubishi.
Before You Begin
1, Connect your A/V receiver to the TV and any addi-
tional devices. See "Setting Up TV Inputs," page 10
and "TV Connections," page 14.
Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See "IR Emitter Placement," page 46.
3, Set the TV's remote control to TV mode using the
side button.
Setup to Control A/V Receiver Power and Volume
1, Open the Inputs > AVR screen in one of two ways:
If using the New Device Found screen for the
A/V receiver, highlight NetComrnand and press
ENTERto open the AVR screen.
If performing NetCommand setup at any time
after Auto Sensing:
Press MENU,highlight Inputs, and highlight AVR
to open the AVR menu.
The first function highlighted in the AVR screen is
always Power. Aim the TV's remote control at the
TV and press ENTERto begin learning for Power.
Inputs > AVR screen, Perform
NetCommand IR "learning" for A/V
receiver power and volume keys,
3,
When the Power text starts flashing, aim the A/V
receiver's remote control at the TV and hold the
POWERor POWERONkey until a check mark appears
next to Power.
If the text stops flashing before the check mark
appears, repeat this step.
To remove the key from NetCommand control,
press the CANCELkey while the key name is
highlighted.
4, Press the V key on the TV's remote control to highlight
other keys in the list. Repeat steps 2 and 3 for each addi-
tional function you wish to control through NetCommand.
If the A/V receiver has a separate POWEROFFkey,
press T on the TV's remote to highlight Power Off.
Repeat steps 2 and 3 to "learn" the POWEROFFkey.
If the device has no POWEROFFkey, skip this step.
6_ When finished "learning" the power and volume
keys, either
To watch TV, press BACK.
To continue with NetCommand setup to control
switching of A/V receiver inputs, highlight
NEXT and press ENTER.