Operation Manual

68 5. NetCommand IR Control (838 Series)
For assistance call 1(800) 332-2119
Operating NetCommand-Controlled Devices, continued
Key Name in
Learning Screen
Special Operation Description and Setup How to Use
Menu Displaying a Menu for the Current Device
“Learn” the
MENU key on the original remote in the
Menu learning position.
Press TOOLS and number 3 to send the menu
signal to the device.
Guide Displaying the On-Screen Program Guide
(cable box or satellite receiver)
1. “Learn” the
GUIDE key on the original remote in
the Guide learning position.
2. Learn the PAGE UP and PAGE DOWN keys of the
original remote in the Page Up and Page
Down learning positions.
1. While watching the device, press GUIDE to
display the guide.
2. Press CH/PAGE to send the Page Up/Dn com-
mands for the guide.
Enter ENTER-Key Functions (cable boxes, satellite receivers, etc.)
Some devices have two keys that have “enter” functions. One key is for menus and is often labelled
SELECT or OK . A second key is for use with number keys for direct channel selection. NetCommand
uses the same ENTER key for both operations.
When
ENTER has a menu or guide function or
when the original remote control uses the same
key for menus and channel selection:
Learn the ENTER , SELECT, or OK key in the
NetCommand Enter learning position.
1. Press MENU or GUIDE to display the device’s
menu or guide.
2. Press ENTER within the menu and
NetCommand will send the Enter signal for
menus.
Enter (digits) When ENTER is for channel changes, i.e., the origi-
nal remote control has a separate ENTER key for
this function):
Learn the ENTER key for channel selection in
the NetCommand Enter (digits) learning posi-
tion. Use this learning position only if the original
remote control has separate keys for Enter in
menus and Enter for channel selection.
Press digit key(s) and then press ENTER .
NetCommand will send the Enter signal for
channel selection.
Cancel CANCEL as the Cancel or Exit Function
“Learn” the Cancel or Exit function in the
NetCommand Cancel learning position
1. Press
MENU or GUIDE to display the menu or
guide.
2. Press CANCEL and NetCommand will send
the Cancel or Exit signal.
—
(separator)
The symbol “—” can serve as the separator
between a digital channel’s main and sub-channel
digits, e.g., digital channel 12-1 (main channel is
12, sub-channel is 1).
“Learn” the channel separator function in the
NetCommand – (separator) learning position.
Press digit key(s) and press
CANCEL .
NetCommand will send the channel-separator
signal.